Right click each one and Name then GND.Ĭlick RatsNest again - may to wiggle the final corner a little so you don't have overlap. Place this just outside the perimeter of the board, start at a corner and go all the way around. When you think its pretty good, draw in ground planes.ĭraw:Polygon. Place all your parts, click Tools:RatsNest every couple of parts to check on the trace "rubberbands". Now the board: File:Switch to Board, and ok to create from new if one doesn't exist (whatever the question is). Right click on a power trace, select Properties, change the Net Class to power. Once you have the schematic and the parts are all connected, select Edit:Net Classes, and update the defualt to 10 mil wide, 12 mil drill, 10 mil clearance, and add one for power, maybe 20 mil wide, 24 mil drill, 10 mil clearance. There's ways to get around or re-do all kinds of things. You can always rename the pins to have different numbers - add an 'a' to the end - then rename them to what you want.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
May 2023
Categories |